2. Open the printer’s front cover by placing your fingers on the grooves on both sides of the cover
as shown below, and then pull it towards you.
3. Remove the developer cartridge and the photoconductor unit by holding the photoconductor
unit’s casing by the handle and pulling it out of the printer.
4. Remove any dirt inside the printer with a clean, dry, lint-free cloth. Do not use compressed air.
If you have paper feed problems, clean the paper roller by wiping the roller with a clean, dry,
lint-free cloth.
EPSON AcuLaser M1200 Series User’s Guide
Cleaning and Transporting the Printer 81
To Next Page
Loading...
