Epson Artisan 810 - Page 138

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
DISASSEMBLY/ASSEMBLY Disassembly Procedures 138
Confidential
8. Tighten the screws (x2) in the order shown in Fig. 4-65 while holding the
thickness gauge.
Figure 4-65. Assembling the Printhead (5)
9. To seal more reliably the joint between the Ink Supply Tube and the Printhead by
making the SEAL JOINT,H adhere more tightly, follow the steps below.
9-1. Mark the 0 digit side of the tightened screws (x2) in Step 8 with a felt pen
or the like.
9-2. Loosen the marked screws by 180 degrees.
9-3. To make the gap even between the joint of the Printhead and the Ink
Supply Tube, move your finger to the right and then to the left while
pressing the side of the Ink Supply Tube shown in
Fig. 4-66 gently toward
the rear of the printer.
Figure 4-66. Assembling the Printhead (6)
2
1
C.B.P. 2x10 (2.0±0.3Kgfcm)
Tighten the second screw while holding both
ends of the thickness gauge.
1) Mark this part with a felt pen
or the like.
3) Move your finger in the order shown below while pressing gently the part above
enclosed in the broken line to the rear. Make sure that the gap between the joint of
the Printhead and the Ink Supply Tube is even.
2
1
Make this gap even.
2) Loosen the marked
screws by 180 degrees.