Epson Artisan 810 - Page 191

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
DISASSEMBLY/ASSEMBLY Disassembly/reassembly procedures specific to Artisan 710/PX710W/TX710W 191
Confidential
2. Remove the screw (x1) that secures the Grounding Plate M/B, and remove the
Grounding Plate M/B.
Figure 4-184. Removing the Grounding Plate M/B
3. Disconnect the cables and FFCs connected to the section B of the Main
Board. (See
Fig. 4-183.)
4. Remove the screw (x1) that secures the Right Cable Frame and the Main
Board. (See
Fig. 4-185.)
5. Remove the screws (x4) that secure the Main Board Unit and remove the
Main Board Unit.
Figure 4-185. Removing the Main Board
C.B.S. 3x6 (7±1Kgfcm)
Grounding Plate M/B
Positioning hole & dowel
Holder IC Shield Plate
Step 4
C.B.P. 3x10 (6±1Kgfcm)
C.B.S. 3x6 (7±1Kgfcm)
C.B.P. 3x8 (6±1Kgfcm)
Positioning hole & dowel
Main Board Unit
Right Cable Frame
C.B.S. 3x4 (8±1Kgfcm)