Epson Artisan 810 - Page 192

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
DISASSEMBLY/ASSEMBLY Disassembly/reassembly procedures specific to Artisan 710/PX710W/TX710W 192
Confidential
 Align the positioning holes (x2) of the Main Board Unit with the
dowels (x2) of the Base Frame. (See
Fig. 4-185.)
 Align the dowels (x2) of the Main Board Unit with the
positioning holes (x2) of the Holder IC Shield Plate. (See
Fig.
4-185.)
 Align the dowel (x1) of the Main Board Unit with the
positioning hole (x1) of the Right Cable Frame. (See
Fig. 4-185.)
 Insert the rib (x1) of the Grounding Plate M/B to the hole of the
Main Board Unit, and align the positioning hole (x1) of the
Grounding Plate M/B with the dowel (x1) of the Main Board
Unit, and attach the Grounding Plate M/B. (See
Fig. 4-185, Fig.
4-186.)
Figure 4-186. Attaching the Grounding Plate M/B
Hole
Rib
 When attaching the CR Encoder FFC, follow the procedures
below.
1. Put the CR Encoder FFC through the ferrite core.
2. Connect the CR Encoder FFC to the connector (CN6) on
the Main Board.
3. Insert the rib of the Ferrite Core Holder B to the hole of the
Main Board, and secure it with the screw (x1).
Figure 4-187. Attaching the CR Encoder FFC
 For routing the FFCs, see "4.4 Routing FFC/cables" (p.196).
A D J U S T M E N T
R E Q U I R E D
 When replacing the Main Board, the MAC address need to be
set if the EEPROM data could not be read from the old Main
Board. (See
"5.2.6 MAC Address Setting" (p.217).)
Figure 4-188. Position for the MAC Address Label
 After removing/replacing the Main Board, make the specified
adjustments. (See
Chapter 5 "ADJUSTMENT".)
C.B.S. 3x6 (5±0.5Kgfcm)
CN6
CR Encoder FFC
Ferrite core
Ferrite Core Holder B
Align and insert the rib of
the Ferrite Core Holder B
Label, MAC address