Epson BrightLink EB-725Wi - PC Interactive Mode System Requirements

191
6. Select one of the following as the Pen Tracking Mode depending on the operating system your
computer is using:
• Pen Mode: Windows or Mac
• Mouse Mode: Ubuntu
7. Press the Enter button and press the Menu button to exit the projector's menus.
8. Hover near or tap on the board or the projected image with the interactive pen or your finger.
9. Make sure that PC Interactivity is enabled on the toolbar.
Note: You can use PC Interactive mode when connected over a network or with a USB cable
(connecting via USB is recommended). When connected via USB, enable the USB Display setting
in the projector's Signal I/O menu and connect the computer to the projector's USB-B1 port. When
projecting using USB Display, response time may be slower.
Note: The HDMI3 input is configured to use the USB-B2 port by default. If you are using the HDMI3
input and want to use PC Interactive mode, you may need to change the USB-B2 setting to a
different HDMI port in the Pen/Touch > PC Interactive menu.
You can now operate the computer using the interactive pens or your finger.
PC Interactive Mode System Requirements
Parent topic: Interactive Modes
PC Interactive Mode System Requirements
Your computer system must meet the system requirements here to use PC Interactive mode and Easy
Interactive Tools.
Note: Easy Interactive Driver must be installed and running to use Easy Interactive Tools on a Mac.
Requirement Windows Mac
Operating system Windows 7 SP1 Ultimate, Enterprise,
Professional, and Home Premium (32-
and 64-bit)
macOS 10.12.x, macOS 10.13.x,
macOS 10.14.x, macOS 10.15.x
(64-bit)
Windows 8.1, Pro and Enterprise (32-
and 64-bit)
Windows 10 Home and Pro (32- and
64bit)