195
• To use the pen as a mouse in PC Interactive mode, do the following:
• To left-click, tap the board with the pen tip.
• To double-click, tap twice.
• To right-click, press the button on the side or press and hold the pen on the screen.
Note: To make a long press of the pen act as a right-click on a Mac or PC, set the Pen Tracking
Mode setting to Mouse Mode and set the Press and Hold setting to Right Click.
• To click and drag, tap and drag with the pen.
• To move the cursor, hover over the board without touching it.
Note: You can turn off the hovering feature using the Pen Hovering setting in the projector's
Pen/Touch menu.
Parent topic: Using the Interactive Pens
Pen Calibration
Calibration coordinates the position of the pen with the location of your cursor. You only need to calibrate
the first time you use your projector's interactive features. Calibration results remain until you calibrate
again.
If using the optional Touch unit, be sure to calibrate the pen before performing finger touch calibration.
If you notice positioning discrepancies after doing any of the following, calibrate again:
• Performing Geometry Correction
• Adjusting the image size
• Using the Image Shift feature
To Next Page
Loading...
