200
6. Touch the center of the next circle, then repeat. When you get to the bottom of the column, the next
circle appears at the top of a new column.
Note: If you make a mistake, press the Esc button on the remote control or control panel to go back
to the previous circle. To cancel the calibration process, press and hold the Esc button for 2
seconds.
7. Continue until all of the circles disappear.
Parent topic: Pen Calibration
Using Finger Touch Interactivity
You can use your finger to perform the same functions as the interactive pens when you install the
Touch Unit.
Note: See the online Installation Guide for detailed instructions on installing the optional Touch Unit. You
can use a compatible Touch Unit that you already have or you can purchase one as an optional
accessory .
Touch Unit Safety Instructions
Performing Touch Unit Angle Adjustment
Calibrating for Finger Touch Interactivity
To Next Page
Loading...
