EasyManuals Logo

Epson BrightLink EB-725Wi User Manual

Epson BrightLink EB-725Wi
359 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
31
Setting Up the Projector
Follow the instructions in these sections to set up your projector for use.
Projector Placement
Projector Connections
Installing Batteries in the Remote Control
Installing Batteries in the Pens
Projector Placement
Your ultra-short throw projector is designed to be installed on a wall (with a wall mount) or vertically on a
table (with a table mount) to create an interactive tabletop workspace.
Note: A Touch Unit is optional and must be installed for finger touch operation. Finger touch operation is
available only if the projector is installed on a wall (with a wall mount) and projecting from the front of the
wall, or vertically on a table (with a table mount) and projecting from the top of the table.
Keep these considerations in mind as you select a projector location:
Follow the instructions in the online Installation Guide to install the projector.
Leave plenty of space around and under the projector for ventilation, and do not place it on top of or
next to anything that could block the vents.
If you are using the projector at altitudes above 4921 feet (1500 m), set the High Altitude Mode
setting to On in the projector's Installation menu to ensure the projector's internal temperature is
regulated properly.
Position the projector within reach of a grounded electrical outlet or extension cord.
If installing vertically on a table, a commercially available mount compatible with the VESA Mounting
Interface Standard (100 x 100 mm) is required.
If installing on a wall, the wall mount (V12HA06A05) is required.
For finger touch, make sure the projection surface is flat, smooth, and unwarped with no more than
0.2 inch (5 mm) of unevenness in any direction.
Place the projector so it squarely faces the screen, not at an angle. If you cannot install the projector
squarely facing the screen, correct any resulting image distortion using the projector controls.
Try not to set up the projector in locations subject to high humidity and dust, or in locations subject to
smoke from fires or tobacco smoke.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson BrightLink EB-725Wi and is the answer not in the manual?

Epson BrightLink EB-725Wi Specifications

General IconGeneral
ResolutionWXGA (1280 x 800)
Contrast Ratio2, 500, 000:1
Display Technology3LCD
Speaker16 W
Interactive FeaturesYes, with interactive pen
ConnectivityHDMI, USB, VGA, LAN
Wireless ConnectivityOptional (via accessory)
Dimensions356 x 395 x 133 mm
Operating Humidity20% to 80%
Light SourceLaser
Operating Temperature5°C to 40°C

Related product manuals