202
Performing Touch Unit Angle Adjustment
Adjust the angle of the laser light coming from the Touch Unit so that the Touch Unit can detect the
position of your fingers. Once you have performed angle adjustment for the Touch Unit, perform touch
calibration.
Note: You can purchase a touch unit as an optional accessory or use a touch unit from an older
BrightLink projector. When using an older model of the touch unit, angle adjustment is not automatic.
Note: Make sure you have calibrated the pens, installed the Touch Unit, and turned the Touch Unit on
before performing angle adjustment. See the online Installation Guide for Touch Unit installation
information and click the link below for pen calibration instructions.
1. Press the Menu button, select the Installation menu, and press Enter.
2. Select Touch Unit and press Enter.
3. Select Touch Unit Setup and press Enter.
To Next Page
Loading...
