243
Controlling an Epson Document Camera
You can control certain document camera features from the projected toolbar when a compatible Epson
document camera is connected.
Note: A document camera toolbar is displayed only when an Epson DC-07, DC-13, or DC-21 document
camera is connected. You must connect the Epson DC-13 and DC-21 cameras via HDMI and the Epson
DC-07 camera via USB to control them from the projector toolbar.
1. Connect an Epson document camera to the projector.
Note: If you are connecting the document camera via HDMI cable, make sure HDMI Link is set to
On in the Signal I/O menu and disable PC Interactivity on the interactive toolbar.
You see a toolbar like this at the bottom of the projected image. You can select the following options
as available. Depending on your document camera model, options may vary.
1 Automatically focuses the image
2 Pauses the image
3 Enlarges the image
4 Rotates the image 180°
5 Captures the image and drawings
6 Records the image
7 Switches sources to the SD Card Viewer
2. To move the toolbar, use the pen or your finger to drag it to the desired location.
Note: A Touch Unit is optional and must be installed for finger touch operation.
To Next Page
Loading...
