!
Caution:
Never use the knob to adjust the tear-off position; this may damage the printer or cause it to
lose the top-of-form position.
Note:
If your paper’s perforation is not properly aligned with the tear-off edge, you can adjust the tear-off
position using the Micro Adjust function as described in “Adjusting the tear-off position” on
page 55.
3. Tear off the printed document using the tear-off edge of the printer cover.
4. To feed the continuous paper backward out of the printer and into the standby position, press the
Load/Eject button.
To remove the remaining paper from the printer, press the Load/Eject button to feed the paper
backward to the standby position. Then open the sprocket covers of the tractor and remove the paper.
!
Caution:
Always tear off the printed document before you press the Load/Eject button. Reverse feeding
several pages at a time may cause a paper jam.
Advancing paper to the tear-off position automatically
To automatically advance the printed documents to the tear-off position, turn on the auto tear-off
mode and select the appropriate page length for continuous paper in the Default Setting mode. See
“Changing default settings” on page 98 for instructions on how to change the default settings.
When auto tear-off is on, the printer automatically advances the paper to the tear-off position
whenever it receives a full page of data or a form feed command followed by no more data.
LQ-590II/LQ-590IIN/LQ-2090II/LQ-2090IIN User’s Guide
Paper Handling 43
To Next Page
Loading...
Need help?
General