ONN
15 cpi
NOO
17 cpi
NON
20 cpi
NNN
PS
N = on, O = off
4. Make sure that the desired font and pitch are selected.
About Your Printer’s Default Settings
The default settings control many printer functions. While you can often set these functions through
your software or printer driver, you may sometimes need to change a default setting from the printer’s
control panel using the Default Setting mode. You can also change some of the settings using the
Printer Setting utility in the printer driver. See “Using Printer Setting” on page 74.
Default Setting mode
The following table is the default settings and the options you can select in the Default Setting mode.
The settings are explained in detail after the table. For instructions on changing the default settings, see
“Changing default settings” on page 98.
Item
Setting / value*
1
Page length for front tractor*
2
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12, 14, 17
Page length for rear tractor*
2
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12, 14, 17
Skip over perforation*
3
Off, On
Auto tear off
Off, On
Auto tear-off wait time
0.5 seconds, 3 seconds
Auto line feed*
3
Off, On
Print direction*
3
Bi-D, Uni-D, Auto
Software
ESC/P2, IBM PPDS
LQ-590II/LQ-590IIN/LQ-2090II/LQ-2090IIN User’s Guide
Control Panel 92
To Next Page
Loading...
Need help?
General