8. Attach the stacker-support wires to the paper tension unit as shown below.
The cut-sheet feeder automatically loads paper when the printer receives data.
If the first line on your page appears too high or low, you can adjust its position using the Micro Adjust
function. See “Adjusting the top-of-form position” on page 56.
Loading paper in the high-capacity cut-sheet feeder
The high-capacity cut-sheet feeder holds up to 150 sheets of paper or up to 25 envelopes.
Follow these steps to load paper in the high-capacity cut-sheet feeder:
!
Caution:
Do not load multipart forms, carbon paper, or labels in the high-capacity cut-sheet feeder.
1. Set the paper release lever to the single-sheet position. Also make sure the paper-thickness lever
(located under the printer cover) is set to 0 if you are using ordinary single-sheet paper. (If you are
using envelopes, see “Envelopes” on page 52 for instructions on setting the paper-thickness lever.)
LQ-590II/LQ-590IIN/LQ-2090II/LQ-2090IIN User’s Guide
Options and Consumables 132
To Next Page
Loading...
Need help?
General