❏ When the printer is in the Default Setting mode, the Menu lights (both the Tear Off/Bin lights)
stay on.
5. Tear Off/Bin ( Set) button
❏ Feeds continuous paper forward to the tear-off position.
❏ Feeds continuous paper backward from the tear-off position to the top-of-form position.
❏ Selects a cut-sheet feeder bin when the cut-sheet feeder is installed.
❏ When the printer enters the Default Setting mode, the button works as the Set button. You can
press the Set button to select the next value of a setting menu.
6. Load/Eject button
❏ Loads a single sheet of paper.
❏ Ejects a single sheet of paper if a sheet is loaded.
❏ Loads continuous paper from the standby position.
❏ Feeds continuous paper backward to the standby position if a sheet is loaded.
7. Micro Adjust
When you hold down the Pause button for three seconds, the printer enters the Micro Adjust mode.
In this mode, you can press the LF/FF and Load/Eject buttons to adjust the top of form or tear off
position. See “Using the Micro Adjust Function” on page 55.
8. LF/FF button
❏ Feeds paper line by line when pressing shortly.
❏ Ejects a single sheet or advances continuous paper to the next top-of-form position when held
down.
9. Pause light
❏ On when the printer is paused.
❏ Flashes when the printer is in the Micro Adjust mode.
❏ Flashes when the print head has overheated.
❏ Only this light is on in sleep mode. All other lights are off.
LQ-590II/LQ-590IIN/LQ-2090II/LQ-2090IIN User’s Guide
Control Panel 89
To Next Page
Loading...
Need help?
General