Auto tear-off wait time
You can select the time from the point printing finished until the paper moves to the tear-off position
for continuous printing. This setting is available when the auto tear-off function is set to on.
Auto line feed
When auto line feed is on, the printer accompanies each carriage return (CR) code received with a line
feed code. Set this to On if printing might continue without line feeding depending on the OS or the
applications used.
Note:
Set to Off when printing from Windows, otherwise a blank line is inserted between the lines.
Print direction
You can select auto print direction (Auto), bidirectional printing (Bi-D), or unidirectional printing
(Uni-D). Printing is normally bidirectional for faster printing; however, unidirectional printing
allows for precise vertical printing alignment.
When print direction is set to Auto, the printer analyzes the data, and then switches automatically
whether to use Bi-D or Uni-D.
Note:
Set to Bi-D when printing from Windows to enable the printer driver's print direction setting. When
Uni-D or Auto is selected, the printer ignores the command from the Windows driver.
Software
When you select ESC/P2 the printer operates in the Epson ESC/P mode. When you select IBMPPDS,
the printer emulates an IBM
®
printer.
0 slash
The zero character has a slash ( ) when this feature is turned on. It has no slash (0) when this feature is
turned off. The slash allows you to easily distinguish between the uppercase letter O and a zero.
LQ-590II/LQ-590IIN/LQ-2090II/LQ-2090IIN User’s Guide
Control Panel 95
To Next Page
Loading...
Need help?
General