Basic Operation
40
8
Place your hand on the paper to flatten it, and
slide the movable edge guide against the
paper.
9
Insert the paper into the paper feed slot until
paper feeding starts automatically.
Do not load backing paper that has no labels on it. The
paper may not be detected and not be fed automati-
cally.
10
Rotate the spindle to remove looseness in the
paper.
11
Close the paper cover.
12
Press the Pause button.
Loading paper (auto cutter model - supply from inside) is
now completed.
CAUTION
If the movable edge guide is not properly
slided against the paper, print position may
become incorrect or a paper jam may occur.
Make sure to follow the guidelines below.
• There should be no gap between the guide
and the paper edge.
• Do not slide the guide against the paper too
tightly.
To Next Page
Loading...
Need help?
General
