Epson Disc producer PP-100N Security User Manual

129
Troubleshooting
• Rubbing
• Lines or streaks are formed
• Blurriness
• Text or lines are shaky
• Incorrect color tones
• Some colors are not printed
• Unevenness in the printing
• Mosaic-like patterns are printed
• Printing is grainy (jagged)
Is there dirt on the disc?
Gently wipe off any dust or dirt adhering to the label side using a
soft cloth or commercial CD cleaner. Do not use benzene, thinner,
or antistatic agents.
See “Handling discs” in the PP-100N Security User’s Guide for
details.
Is the printing surface fully dry?
Do not let other discs get in contact with the printing surface until
the ink on the published disc is dry. Otherwise, marks can be left
where contact is made.
Is the ink drying time set too short?
The ink drying time is the time after label printing is completed until
the disc ink is dried in the printer tray. Set a longer ink drying time.
See “Printer Driver Settings” in the PP-100N Security User’s Guide.
Are you comparing the display on the computer to the printing
results?
The colors shown on the display and the results printed by the
printer use different coloring methods, and this produces
differences in color tones.
Unable to print correctly in the
print area of the disc.
Set the inside diameter and outside diameter of the print area so
that they match the print area of the disc to be printed.
See “Printable Area” in the PP-100N Security User’s Guide for
details. See “Changing the Printable Area” in the PP-100N Security
User’s Guide for the inside diameter and outside diameter setting
procedure.
Printing position is shifted. Correct the printing position if it is shifted.
See “Printing Position Correction” in the PP-100N Security User’s
Guide.
The disc recording surface is
stained with ink.
Is the ink drying time set too short?
The ink drying time is the time after label printing is completed until
the disc ink is dried in the printer tray. Set a longer ink drying time.
See “Printer Driver Settings” in the PP-100N Security User’s Guide.
Is the printer tray dirty?
When the disc recording surface is stained by ink, the printer tray
may be dirty. Clean the printer tray.
See “Disc recording surface is stained with ink” on page 143 in this
guide for the printer tray cleaning procedure.
• After printing, the label surface
ink is sticky or peels off.
• Discs stick together.
Was printing performed outside the recommended print area?
If printing is performed outside the recommended print area, after
printing, the label surface ink may be sticky or peel off, or discs may
stick to each other.
See “Printable Area” in the PP-100N Security User’s Guide for
details.
Symptom/Problem Status Check/Remedy Procedure

Epson Disc producer PP-100N Security Specifications

General

Brand	Epson
Model	Disc producer PP-100N Security
Category	Printer
Language	English