Epson Disc producer PP-100N Security User Manual

21
Preparation
After setup of this product is complete, install the software required for using this product to the client computer. See
the PP-100N Security User’s Guide for details on the installation procedure.
Connecting the authentication keypad
Connect the authentication keypad for entering the user number and PIN during the authentication process.
1
Remove the two screws on the rear side that secure the top plate.
2
Open the disc cover.
If you are using more than one unit of this product in the same environment and back up
the first unit and then restore the backup data on the second and subsequent units, the
configuration information of the first unit is saved, so you do not need to perform the
following work. See “Backing up and restoring data” on page 104 in this guide for details
on the backup and restoration procedure.
• “Output device settings” on page 47 in this guide
• “Notification email transmission settings” on page 50 in this guide
• “Registering users” on page 79 in this guide
Always use one of the following USB keypads as the authentication keypad.
• AKP09EU (Targus)
• KP25B (Micro Innovations)
Note
s

Epson Disc producer PP-100N Security Specifications

General

Brand	Epson
Model	Disc producer PP-100N Security
Category	Printer
Language	English