65
Administration and Management
Opening the disc cover
1
If the disc cover is locked, unlock it.
See “Unlocking the disc cover” on page 63 in this guide for the procedure to unlock the lock.
2
Hold the handle, and open the disc cover in the direction indicated by the arrow in the
figure below.
• Do not open the disc cover while a job is being processed (BUSY LED is flashing). Doing
so may affect the quality of writing or printing.
• If you open the disc cover while a job is being processed, an alarm tone sounds and
the status of the current job becomes standby. If you close the disc cover, job
processing resumes automatically.
• If a job is being processed, first pause the job and then open the disc cover. See
“Pausing jobs” on page 73 in this guide for the procedure to pause a job.
• For safety reasons, never insert your hand while the arm is operating.
• Do not operate the stacker while the arm is operating. Doing so may damage the arm.
• Do not leave the disc cover open. If the disc cover is left open, a slow beeping alarm
tone sounds. The alarm tone sounds every 10 seconds and then stops. After 60 seconds
elapse, it changes to a fast beeping warning tone. The warning tone does not stop until
the disc cover is locked.
• If notification email transmission is set, an email is sent to notify the administrator if the
disc cover is left open for 60 seconds, or is closed for 10 seconds without being locked.
To Next Page
Loading...
Need help?
General