Epson DS-530 II

3.
Load the envelopes into the input tray facing down making sure that the opened edge
(ap
side) of the
envelope is facing to the side. For envelopes with the opened edge (ap side) on the shorter side, you can load
the envelope with the opened edge
(ap
side) facing up.
Slide the envelopes into the ADF until they meet resistance.
c
Important:
Do not load envelopes with adhesives on them.
Note:
❏ Envelopes that are not opened by cutting sharply at the ap edge may not be scanned correctly.
❏ Envelopes that have not yet been sealed can be loaded with the ap open and facing up.
4.
Slide the edge guides to t the edge of the envelopes making sure there are no gaps between the envelopes and
the edge guides. Otherwise, the envelopes may be fed skewed.
Specications of Originals and Placing Originals > Placing Originals > Envelopes
57