Epson DS-530 II

Maintenance
Cleaning the Flatbed Scanner Dock
To keep your Flatbed Scanner Dock in optimum condition, follow the steps below to clean it periodically.
c
Important:
❏ Never use alcohol, thinner, or corrosive solvent to clean the Flatbed Scanner Dock. ese chemicals can damage
the Flatbed Scanner Dock components and the case.
❏ Be careful not to spill liquid into the scanner mechanism or electronic components. is could permanently
damage the mechanism and circuitry.
❏ Do not spray lubricants onto the Flatbed Scanner Dock.
❏ Never open the Flatbed Scanner Dock case.
1.
Press the
button to turn
o
the sheet feed scanner.
Note:
ere is no power button on the atbed scanner.
2.
Unplug the AC adapter, and then disconnect the USB cable that is connected to the computer from the Flatbed
Scanner Dock.
3.
Wipe o any dirt on the outer case with a so cloth.
If the case is very dirty, dampen a so cloth with water and wring it out thoroughly, and then wipe o any
remaining stains. Next, use a so dry cloth to wipe the case.
Using the Flatbed Scanner Dock > About the Flatbed Scanner Dock > Maintenance
143