Buttons and Lights on the Control Panel
Buttons
A
Power button Turns the scanner on or o.
B
Double feed detection skip button Normally, an error occurs when detecting double feeds
when loading envelopes, plastic cards, originals with labels
or stickers, and so on. Press the
button before scanning
to skip this error once (one sheet). The light is on when this
is enabled. Follow the steps below to restart scanning when
a double feed error has occurred (the error light
ashes).
1. Open the scanner cover, and then remove the originals.
2. Close the scanner cover, and then press the
button.
3. Load the originals.
4. Restart scanning by pressing the start button or the
software button.
C
Slow mode button Slow down the feeding speed when scanning. The light is on
when this is enabled.
Press this button in the following situations:
❏ when originals jam frequently
❏ when loading thin originals
D
Stop button ❏ Cancels scanning.
❏ Finishes Automatic Feeding Mode.
E
Start button ❏ Starts scanning.
❏ Press this when cleaning the inside of the scanner.
Related Information
& “Placing Plastic Cards” on page 41
Scanner Basics
>
Buttons and Lights on the Control Panel
>
Buttons
20
To Next Page
Loading...
