When writing completes normally, the projector enters standby
status.
Power
Blue - On
When the projector is in standby status, remove the USB flash
drive.
Reflecting saved settings to other projectors
a
Disconnect the power cord from the projector, and check that all
of the projector's indicators have turned off.
b
Connect the USB flash drive containing the saved batch setup file
to the projector's wireless LAN unit port.
a
• When the USB flash drive contains 1 to 3 types of batch
setup files, the file is reflected to the projector with the same
model number. If there are multiple files for a projector with
the same model number, the settings may not be reflected
correctly.
• When there are four or more types of batch setup files on the
USB flash drive, the settings may not be reflected correctly.
• Do not store any data except for the batch setup file on the
USB flash drive. If the USB flash drive contains data other
than the batch setup file, the settings may not be reflected
correctly.
Batch Setup
158
To Next Page
Loading...
Need help?
General
