Others menu
Submenu Function
Priority Gate-
way
For the priority gateway, select either Wired or Wireless.
AMX Device Dis-
covery
When you want to allow the projector to be detected by
AMX Device Discovery
g
, set this to On. Set this to Off if
you are not connected to an environment controlled by a
controller from AMX or AMX Device Discovery.
Crestron Room-
View
Set this to On only when monitoring or controlling the
projector over the network using Crestron RoomView
®
.
Otherwise, set this to Off.
s "About Crestron RoomView
®
" p.202
Changes in projector settings take effect upon restarting.
When this is set to On, the following functions are not
available.
• Epson Web Control
• Message Broadcasting (EasyMP Monitor plugin)
Control4 SDDP
Set to On if you want to enable the acquisition of the
device information by
Control4
®
Simple Device Discovery
Protocol (SDDP)
g
.
Submenu Function
Art-Net
*
Art-Net: Set this to On to control the projector using Art-
Net.
s "About Art-Net (EB-L1505U/EB-L1500U/EB-L1405U
only)" p.206
Net/Sub-Net/Universe: Sets the projector's Net/Sub-Net/
Universe.
Start Channel: Sets the start channel that handles Art-
Net.
s "Channel definitions" p.206
Message Broad-
casting
You can switch the Message Broadcasting function to enable
or disable.
You can download Message Broadcasting and its Operation
Guide from the following Web site.
http://www.epson.com
* EB-L1505U/EB-L1500U/EB-L1405U only
Reset menu
Resets all of the network settings.
List of Functions
144
To Next Page
Loading...
