Image Shape
60
e
Select Quick Corner and press [Enter]. Then press [Enter] again if
necessary.
You see the area selection screen.
f
Use the arrow buttons to select the area of the image you want to
adjust. Then press [Enter].
a
To reset the Quick Corner corrections, hold down [Esc] for
about 2 seconds while the area selection screen is displayed, and
then select Yes.
g
Press the arrow buttons to adjust the image shape as necessary.
To return to the area selection screen, press [Enter].
a
• You can also select the area by pressing the following numeric
buttons on the remote control:
• [1] selects the upper left area.
• [3] selects the upper right area.
• [7] selects the lower left area.
• [9] selects the lower right area.
• If you see this screen, you cannot adjust the shape any further
in the direction indicated by the gray triangle.
h
Repeat steps 6 and 7 as needed to adjust any remaining corners.
i
When you are finished, press [Esc].
The Geometry Correction setting is now set to Quick Corner in the
projector's Installation menu.
To Next Page
Loading...
