Epson EB-W06 User Manual

Setting Up Monitoring Using SNMP
115
Network administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor projectors. If
your network uses this software, you can set up the projector for SNMP
monitoring.
a
Press the [Menu] button, select the Network menu, and press [Enter].
b
Select Network Configuration and press [Enter].
c
Select the Notifications menu and press [Enter].
d
Set the SNMP setting to On.
e
Enter up to two IP addresses to receive SNMP notifications, using 0 to
255 for each address field.
a
Do not use these addresses: 224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255). This projector supports
SNMP agent version 1 (SNMPv1).
f
Enter the SNMP Community Name up to 32 alphanumeric characters
long.
g
When you finish selecting settings, select Complete and follow the on-
screen instructions to save your settings and exit the menus.
gg Related Links
• "List of Functions" p.10

Epson EB-W06 Specifications

General

Contrast Ratio	16, 000:1
Weight	2.5 kg
Projection System	3LCD
Aspect Ratio	16:10
Projection Ratio	1.30 - 1.56:1
Screen Size	33 inches - 320 inches
Projection Lens F Number	1.49 - 1.72
Projection Lens Focal Length	16.9 - 20.28 mm
Projection Lens Focus	Manual
Security	Kensington lock, Password protection
3D	No
Resolution	WXGA (1280 x 800)
Brightness	3700 lumens
Lamp Life	12000 hours (Eco)
Keystone Correction	Vertical: ±30 degrees, Horizontal: ±30 degrees
Connectivity	HDMI, VGA, USB
LCD Panel	0.59-inch with MLA (D10)
Lamp	UHE, 210 W
Zoom	Factor: 1.2
Noise Level	37 dB (Normal)
Dimensions	302 x 237 x 82 mm (Width x Depth x Height)
Power Consumption	0.3 W (Standby)