Projector Network Settings - Network Menu
144
Network Menu - Notifications Menu
Settings on the Notifications menu let you receive an email notification if a
problem or warning occurs in the projector.
s Network > Network Configuration > Notifications
Setting Options Description
Mail Notification On
Off
Set to On to send an email to the preset
addresses when a problem or warning
occurs with a projector.
SMTP Server IP address Enter the IP address for the projector's
SMTP server using 0 to 255 for each
address field.
Do not use these addresses: 127.x.x.x,
192.0.2.x or 224.0.0.0 through
255.255.255.255 (where x is a number
from 0 to 255).
Port Number 0 to 65535 (default
is 25)
Select a number for the SMTP server
Port Number.
Setting Options Description
From Up to 32
alphanumeric
characters
Up to 64
alphanumeric
characters from the
Web browser
(do not use " ( ) , : ;
< > [ \ ] spaces)
Enter the email address of the sender.
Address 1 Setting
Address 2 Setting
Address 3 Setting
Enter the e-mail address, and select the
alerts you want to receive. Repeat for up
to three addresses.
SNMP On
Off
Set to On to monitor the projector using
SNMP. To monitor the projector, you
need to install the SNMP manager
program on your computer. SNMP
should be managed by a network
administrator.
Trap IP Address 1
Trap IP Address 2
IP address Enter up to two IP addresses to receive
SNMP notifications, using 0 to 255 for
each address field.
Do not use these addresses: 127.x.x.x or
224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255).
Community Name Up to 32
alphanumeric
characters
(do not use spaces
and any symbols
other than @)
Set the SNMP community name.
PJLink Notification On
Off
Enables or disables the PJLink
notification function.
Available only for models that support
wired LAN projection.
To Next Page
Loading...
Need help?
General
