If you are having a problem with the projector, first check the projector's indicators and refer to "Reading the Indicators" below.
See the following if the indicators do not show clearly what the problem might be.
s "When the Indicators Provide No Help" p.108
Reading the Indicators
The projector is provided with the following four indicators that indicate the operating status of the projector.
A
Power indicator Indicates the projector's status.
B
Status indicator Indicates the projector's status.
C
Lamp indicator Indicates the projection lamp status.
D
Temp indicator Indicates the internal temperature status.
Indicators Status Explanation
Power supply Status
Blue - Lit Off
Standby condition Power is being supplied to the projector. When the [t] power button is pressed in this condition, projection
starts.
Network monitoring
status
The projector is being monitored and controlled over a network (when Standby Mode is set to
Communication On). If the power cord is disconnected and connected in this status, the power indicator
flashes blue.
Blue - Lit Blue - Flashing
Warm-up status This is the status immediately after turning on the projector. Warm-up takes approximately 30 seconds after
the lamp turns on. In this status you cannot turn off the projector, even if you press the [t] power button.
Problem Solving
104
To Next Page
Loading...
Need help?
Image
