Problems when Projection Starts
The projector does not turn on
Check Remedy
Did you press the [t] power button? Press the [t] power button to turn the power on.
Are the indicators switched off? The power cord is not connected correctly or power is not being fully supplied.
Disconnect and then reconnect the power cord.
s
"From Installation to Projection" p.34
Check that your electrical outlet or power source is functioning correctly.
Do the indicators turn on and off when the power cord is touched? There is probably a poor contact in the power cord, or the power cord may be defective. Reinsert the power cord. If this
does not solve the problem, stop using the projector, disconnect the power cord from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Is the Control Panel Lock set to Full Lock? Press the [t] power button on the remote control. If you do not want to use Control Panel Lock, change the setting to
Off.
s Settings - Control Panel Lock p.88
Is remote control operation restricted? Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.88
Other Problems
No sound can be heard or the sound is faint
Check Remedy
Check that the audio/video cable is securely attached to both the
projector and audio source.
Disconnect the cable from the Audio port, and then reconnect the cable.
Is the volume for the projector or the connected equipment set to the
minimum?
Adjust the volume so that sound can be heard.
s Settings - Volume p.88
s
"Adjusting the Volume" p.46
Problem Solving
115
To Next Page
Loading...
Need help?
Image
