Solving Network Problems
155
Check the solutions in these sections if you have problems using the projector
on a network.
gg Related Links
• "Solutions When Network Alert E-Mails are not Received" p.155
• "Solutions When the Image Contains Static During Network Projection"
p.155
Solutions When Network Alert E-Mails are not
Received
If you do not receive an e-mail alerting you to problems with a projector over
the network, try the following solutions:
• Make sure the projector is turned on and connected to the network
correctly. (If an error shuts down the projector, the email may not be
delivered.)
• Make sure you set up the projector e-mail alert settings correctly on the
projector's network Notifications menu or in the network software.
• Set the Standby Mode setting to Communication On in the projector's
ECO menu so the network software can monitor the projector in standby
mode.
Change the Port setting according to your network environment.
s ECO > Standby Mode > Standby Mode
• Make sure your electrical outlet or power source is functioning correctly.
gg Related Links
• "Network Menu - Notifications Menu" p.125
Solutions When the Image Contains Static During
Network Projection
If the projected image contains static during network projection, try the
following solutions:
• Check for any obstacles between the access point, the computer, the mobile
device, and the projector, and change their positions to improve
communication.
• Make sure that the access point, the computer, the mobile device and the
projector are not too far apart. Move them closer together and try to
connect again.
• If the wireless connection is slow or your projected image contains noise,
check for interference from other equipment, such as a Bluetooth device or
microwave. Move the interfering device farther away or expand your
wireless bandwidth.
• Reduce the number of connected devices if the connection speed declines.
To Next Page
Loading...
