Saving a User's Logo Image
76
You can save an image on the projector and display it whenever the projector
turns on. You can also display the image when the projector is not receiving
an input signal. This image is called the user's logo screen.
You can select a photo, graphic, or company logo as the user's logo, which is
useful in identifying the projector's owner to help deter theft. You can prevent
changes to the user's logo by setting up password protection.
a
• Once you save a user's logo, you cannot return to the factory default
logo.
• If the User's Logo Protection setting is set to On in the Password
Protection setting menu, set to Off before saving the user's logo.
a
Display the image you want to project as the user's logo.
b
Press the [Menu] button on the control panel or remote control.
c
Select the Extended menu and press [Enter].
d
Select User's Logo and press [Enter].
You see a prompt asking if you want to use the displayed image as a
user's logo.
a
Adjustments such as Keystone, E-Zoom, or Aspect are
temporarily canceled when you select User's Logo.
e
Select Yes and press [Enter].
You see a selection box overlaying your image.
a
Depending on the current image signal, the screen size may
change to match the resolution of the image signal.
To Next Page
Loading...
Need help?
General
