Laser Safety Information
169
This projector is a Class 1 laser product that complies with the IEC/EN60825-
1:2014 international standard for lasers. Follow these safety instructions when
using the projector.
Warning
• Do not open the projector's case. The projector contains a high-powered laser.
• Possibly hazardous optical radiation emitted from this product. Do not look at
operating light source. Eye injury may result.
Caution
Do not disassemble the projector when disposing of it. Dispose according to your
local or national laws and regulations.
a
• The projector uses a laser as the light source. The laser has the
following characteristics.
• Depending on the surroundings, the brightness of the light source
may decline. The brightness declines a lot when the temperature
gets too high.
• The brightness of the light source declines the longer it is used.
You can change the relationship between usage time and decline in
brightness settings.
• Note the following about light source calibration.
• Whenever the usage time reaches 100 hours, calibration starts
automatically for the light source when the projector is turned off.
However, this does not start automatically in the following
situations:
• If you use the projector continuously for more than 24 hours
• If you regularly turn off the projector by shutting off the power
outlet
• When performing light source calibration, the difference between
the white balance and the brightness level for the light source is
corrected.
gg Related Links
• "Laser Warning Labels" p.169
Laser Warning Labels
Laser warning labels are attached on the projector.
Inside
Side
Except for North/South America
As with any bright source, do not stare into the beam, RG2 IEC/EN 62471-
5:2015.
For North/South America
To Next Page
Loading...
