Projector Indicator Status
94
The indicators on the projector indicate the projector status and let you know
when a problem occurs. Check the status and color of the indicators and then
refer to this table for a solution.
a
If the indicators display a pattern not listed in the table below, turn the
projector off, unplug it, and contact Epson for help.
A
Status indicator
B
Lamp indicator
C
Temp (temperature) indicator
Projector status
Indicator and status Problem and solutions
Status: Lit blue
Lamp: Off
Temp: Off
Normal operation.
If you set USB Power to On, the status indicator turns
blue even when the projector is in standby mode (when
the power is off).
s Extended > Operation > USB Power
Indicator and status Problem and solutions
Status: Flashing blue
Lamp: Off
Temp: Off
Warming up, shutting down, or cooling down.
When warming up, wait about 30 seconds for an image
to appear.
All buttons are disabled during warm-up, shutting
down, and cooling down.
Status: Off
Lamp: Off
Temp: Off
Standby or sleep mode.
When you press the power button, projection starts.
Status: Indicator status
varies
Lamp: Off
Temp: Flashing orange
Projector is too hot.
• Make sure that the vents and air filter are not clogged
with dust or obstructed by nearby objects.
• Clean or replace the air filter.
• Make sure the environmental temperature is not too
hot.
Status: Off
Lamp: Off
Temp: Lit orange
Projector has overheated and turned off. Leave it turned
off to cool down for 5 minutes.
• Make sure that the vents and air filter are not clogged
with dust or obstructed by nearby objects.
• Make sure the environmental temperature is not too
hot.
• Clean or replace the air filter.
• If operating the projector at high altitude, set the High
Altitude Mode setting to On in the projector's menu.
s Extended > Operation > High Altitude Mode
• If the problem persists, unplug the projector and
contact Epson for help.
To Next Page
Loading...
