Epson EH-TW6250 - Adjusting a Fuzzy or Blurry Image; Adjusting an Image that Contains Noise or Static; Fixing Partial Image Problems

Solving Image Problems
98
b
Adjust the image shape using the Keystone settings.
s Settings > Keystone > H/V-Keystone
s Settings > Keystone > Quick Corner
gg Related Links
• "Projector Feature Settings - Settings Menu" p.70
• "Correcting the Image Shape with the Horizontal Keystone Slider" p.36
• "Correcting the Image Shape with the Keystone Button" p.37
• "Correcting the Image Shape with Quick Corner" p.38
Adjusting a Fuzzy or Blurry Image
If the projected image is fuzzy or blurry, try the following steps until the
problem is solved.
a
Adjust the image focus using the focus slider.
b
Check the following items:
• Position the projector close enough to the screen.
• Position the projector so the keystone adjustment angle is not so
wide that it distorts the image.
c
Clean the projector's lens.
a
To avoid condensation on the lens after bringing the projector in
from a cold environment, let the projector warm up to room
temperature before using it.
d
Adjust the Sharpness setting in the projector's Image menu to improve
image quality.
s Image > Expert Settings > Sharpness
e
If you are projecting from a computer, use a lower resolution or select a
resolution that matches the projector's native resolution.
gg Related Links
• "Image Quality Settings - Image Menu" p.67
• "Focusing the Image Using the Focus Slider" p.41
• "Cleaning the Lens" p.79
Fixing Partial Image Problems
If only a partial computer image is displayed, try the following steps until the
problem is solved.
a
Adjust the size of the projected image using the zoom slider on the
projector.
b
Make sure you selected the correct projection mode. You can select this
using the Projection setting in the projector's Extended menu.
c
Check your computer display settings to disable dual display and set the
resolution within the projector's limits. (See your computer manual for
details.)
gg Related Links
• "Projector Setup Settings - Extended Menu" p.72
Adjusting an Image that Contains Noise or Static
If the projected image contains electronic interference (noise) or static, try the
following steps until the problem is solved.