Epson FX Series User Manual

S
Schematic, 331
Script Mode, 71-72
ESCape “S0” turns Superscript Mode on. ESCape “S1” turns Subscript
Mode on. ESCape “T” turns either Script Mode off.
Self test for printer. See Test
Semicolons, iv, 45
Sensor. See Paper-out sensor
Separator, paper. See paper
Serial board. See Interface
Set-up operations for printer, 13-36
Seven-bit systems, 309-31
graphics with, 311
limitations of, 132, 137, 309-310
test for computer’s type, 309
user-defined characters with, 202, 205, 207, 209
Single-sheet printing, 109-110
Skip-over-perforation, 107-109
ESCape "N" or DIP switch 2-4 turns it on. ESCape “O” turns it off.
Space. See Blank space.
Spacing. See Line spacing; Proportional spacing
Special characters, 85
Specifications. See Technical specifications
Spread-sheet printing, 321
Statement program, 231-238
STOP. See END
Subscript. See Script Mode
Superscript. See Script Mode
Switches. See DIP switches
T
Tabs
effect of pitch on, 122
margin settings with. See Margins
horizontal, 119-122
CHR$(9) or CHR$(137) activates.
ESCape “D”CHR$(n1)CHR$(n2) ... CHR$(n
k
)CHR$(0)
sets horizontal tabs.
vertical, 122-128
CHR$(11) activates. ESCape “B”CHR$(n1)CHR$(n2) ...
CHR$(n
k
)CHR$(0) sets vertical tabs.
ESCape “b”CHR$(N)CHR$(n
1
)CHR$(n
2
) ... CHR$(n
k
)CHR$(1)
sets the vertical channel to N. ESCape “/“CHR$(n) selects
channel n.
channels, 126-128
Technical specifications, 327-331
347

Epson FX Series Specifications

General

Connectivity	Parallel
Paper Handling	Friction feed, Tractor feed
Emulation	Epson ESC/P
Noise Level	55 dB(A)
Print Method	Impact dot matrix