4.
Select Wi-Fi Setup Wizard.
5.
Select the SSID for the wireless router from printer's control panel, and then press the OK button.
Note:
❏ If the SSID you want to connect to is not displayed on the printer's control panel, press the
button to update the
list. If it is still not displayed, select Other SSIDs, and then enter the SSID directly.
❏ If you do not know the SSID, check if it is written on the label of the wireless router. If you are using the wireless
router with its default settings, use the SSID written on the label.
6.
Enter the password.
Select whether or not you print a network connection report aer nishing the settings.
Note:
❏ e password is case-sensitive.
❏ If you do not know the network name (SSID) check if the information is written on the label of the wireless router. If
you are using the wireless router with its default settings, use the SSID on the label. If you cannot nd any
information, see the documentation provided with the wireless router.
7.
When you have setup nished, and then press the OK button.
Note:
If you fail to connect, load paper, and then press the
button to print a network connection report.
Related Information
& “Entering Characters” on page 24
& “Checking the Network Connection Status” on page 235
Making Wi-Fi Settings by Push Button Setup (WPS)
You can automatically set up a Wi-Fi network by pressing a button on the wireless router. If the following
conditions are met, you can set up by using this method.
❏ e wireless router is compatible with WPS (Wi-Fi Protected Setup).
❏ e current Wi-Fi connection was established by pressing a button on the wireless router.
1.
Select Wi-Fi Setup on the home screen.
To select an item, use the
u
d
l
r
buttons, and then press the OK button.
2.
Select Wi-Fi (Recommended).
3.
Press the OK button to proceed.
4.
Select Push Button Setup (WPS).
Adding or Replacing the Computer or Devices
>
Re-setting the Network Connection
>
Making Wi-
…
229
To Next Page
Loading...
Need help?
General
