Notices 62
❍ If the liquid crystal solution contained in the LCD panel
on this product leaks out and gets onto your hands,
wash them thoroughly with soap and water. If it gets
into your eyes, flush them immediately with water. If
discomfort or vision problems remain after a thorough
flushing, see a doctor immediately.
❍ Use only a soft, dry cloth to clean the display. Do not
use liquid or chemical cleaners.
Using a Memory Card
❍ Only memory cards designed for the product’s
specifications can be used. (See “Inserting and
Removing Memory Cards” on page 16.)
❍ The methods for using memory cards vary according to
card type. See the documentation included with your
memory card for details.
❍ Do not remove a memory card or turn off the product
while the
ACCESS light is flashing.
Storing, Maintaining, or Transporting the P-2000
❍ Do not store this product outdoors.
❍ Do not store this product near water.
❍ Do not store this product in a location subject to high
temperature or humidity.
❍ Do not store this product in a location subject to rapid
changes in temperature or humidity.
❍ Do not store this product in a location subject to direct
sunlight or strong light sources.
❍ Unplug this product from the power outlet before
cleaning it. Use a damp cloth for cleaning and do not
use liquid or aerosol cleaners.
❍ Remove the battery and unplug this product and refer
servicing to qualified service personnel under the
following conditions: The power cord or plug is
damaged; liquid has entered this product or its options;
this product or its options have been dropped or the case
is damaged; this product or its options do not operate
normally or exhibit a distinct change in performance.
WARNING: The cords included with this product contain
chemicals, including lead, known to the State of California
to cause birth defects or other reproductive harm. Wash
hands after handling.
(provided in accordance with Proposition 65 in Cal. Health
& Safety Code § 25249.5 et seq)
To Next Page
Loading...
Need help?
General
