Connection Modes
10
Preparing to Connect
Follow the steps below to connect the computer and the projector via a
network using EasyMP Network Projection.
A Install EasyMP Network Projection on the computer to be
connected.
s "Installing" p.7
B Make network settings on the computer and put it into
network connection status.
See the documentation supplied with your computer or LAN
adapter for more details on network settings.
q
When the computer you are using is normally connected to the network,
you do not need to make network settings on the computer.
C Make network settings on the projector and put it into
network connection status.
You can make network settings from the projector's Network
menu.
See your projector User’s Guide for details.
D Press the LAN button on the remote control.
The LAN standby screen is displayed.
If there is no signal for the current input source when a connection
is established with the computer, it automatically switches to the
LAN source. If it does not automatically switch to the LAN source,
press the LAN button.
E Start EasyMP Network Projection on the computer and
connect with the projector.
s "Connecting to a Projector on a Network and Projecting" p.11
q
If a connection error occurs, a number indicating the type of error is
displayed as follows.
Event ID: 04xx
See your projector User’s Guide for details on Event ID.
To Next Page
Loading...
