Troubleshooting
40
When a connection is made using EasyMP Network Projection, the projected image remains as it is, and a connection
cannot be made from another computer.
Cannot select or change the connection mode.
Are you trying to connect to the projector using Quick
Connection Mode?
If the projector does not support wireless LAN connection, you cannot connect the projector using
Quick Connection Mode.
Connect to the projector using Advanced Connection Mode.
Check Remedy
Did the presenter leave the conference room without
cutting off the network connection?
With EasyMP Network Projection, the computer currently connected can be disconnected when
another computer tries to connect to the projector.
Therefore, when a Projector Keyword is not set for the projector, or if you know the Projector
Keyword, you can disconnect the computer currently connected and then connect your computer to
the projector.
When a Projector Keyword is set for the projector and you do not know the Projector Keyword, restart
the projector and reconnect.
Check Remedy
Is EasyMP Network Projection set to start up using the
same connection mode?
Select Display Connection Mode Selection window on startup on the General settings tab from
Set options. The projector selection screen is displayed after restarting EasyMP Network Projection.
Check Remedy
To Next Page
Loading...
Need help?
Projection System
Power
Weight and Dimensions
