138
3. Hold down the ID button on the remote control while you press the numeric button that matches the
projector's ID. Then release the buttons.
4. Press the ID button on the remote control to check if the ID-setting process worked.
You see a message displayed by the projector.
• If the remote control is listed as On, the remote control ID is set to operate only the listed projector.
• If the remote control is listed as Off, the remote control ID is not set properly. Repeat the steps
above to set the ID to match the projector you want to control.
Parent topic: Projector Identification System for Multiple Projector Control
Adjusting the Color Tone (Color Uniformity)
You can use the Color Uniformity feature to manually adjust the color tone balance in the projected
image.
1. Press the Menu button.
To Next Page
Loading...
Need help?
General