96
Light magenta ink HIKLM000 The light magenta ink cartridge has been removed.
Remedy:
Install the light magenta ink cartridge.
HIKLM001 The model number of the light magenta ink cartridge is different or the model number cannot
be recognized.
Remedy:
Replace the light magenta ink cartridge with a correct one.
Black ink HIKBK000 The black ink cartridge has been removed.
Remedy:
Install the black ink cartridge.
HIKBK001 The model number of the black ink cartridge is different or the model number cannot be
recognized.
Remedy:
Replace the black ink cartridge with a correct one.
Stacker 1 HST1000 The number of discs in the stacker 1 has exceeded the upper limit.
Remedy:
Remove discs so that the number of discs in the stacker 1 falls within the
limit.
HST1001 The stacker 1 has not been installed.
Remedy:
Install the stacker 1.
Stacker 2 HST2000 The number of discs in the stacker 2 has exceeded the upper limit.
Remedy:
Remove discs so that the number of discs in the stacker 2 falls within the
limit.
HST2001 The stacker 2 has not been installed.
Remedy:
Install the stacker 2.
Stacker 3 HST3000 The number of discs in the stacker 3 has exceeded the upper limit.
Remedy:
Remove discs so that the number of discs in the stacker 3 falls within the
limit.
HST3001 Stacker 3 is set for the output stacker in standard mode, external output mode, and error rate
measurement mode. However, the stacker 3 is not installed. Alternatively, the stacker 3 is not
installed in batch mode.
Remedy:
Install stacker 3.
HST3002 Stacker 4 is set for the output stacker in standard mode and external output mode. However,
the stacker 3 is installed instead.
Remedy:
[PP-100II / PP-100 / PP-100N / PP-100AP]
Remove stacker 3.
Disc cover
HDC000 The disc cover is open.
Remedy:
Close the disc cover
Communication HNW000 Either one of the following communication errors occur.
Communication with Discproducer is disabled.
The filter driver has not been attached.
Remedy:
(Other than PP-100N)
(1) Check the power supply of the Discproducer.
(2) Check if the USB cable is securely connected.
(3) Connect the publishing machine, and turn on the power.
[For PP-100N]
(1) Check the power supply of the Discproducer.
(2) Check if the network cable is securely connected.
HNW001 A non-supported version error has occurred, and any of the following has been detected.
(1) Firmware version of the auto loader is not supported.
(2) Firmware version of the drive 1 is different from the supported version.
(3) Firmware version of the drive 2 is different from the supported version.
(3) Firmware version of the printer is not supported.
Remedy:
Upgrade the firmware of the concerning device.
Item INFORMATION code Explanation and Remedies
To Next Page
Loading...
