2011/03/02
Revision: 1 Page: 44
5.1.19 Select MicroWeave printing mode ESC (i
ESC (i Ver 1.00
[Name] Select MicroWeave printing mode [Operation]
[Format] 1BH, 28H, 69H, 01H, 00H, n
[Range of Definition] n=00H, 01H, 30H, 31H
[Function] 1) Selects / deselects the MicroWeave mode.
all parameters : deselects
[Initial State] Non-MicroWeave mode
[Related Commands]
[Setting] Commands whose settings are affected by this command.
This command changes the non-selected state set by either the ESC (G or ESC @
commands.
[Setting] Commands that change the effects of this command.
The ESC (G command sets the non-selected state.
The ESC @ command sets the non-selected state.
[Operation] Commands whose functionality is affected by this command.
None
[Operation] Commands that change the effects of this command.
None
To Next Page
Loading...
Need help?
General