2011/03/02
Revision: 1 Page: 75
6.1.13 Set drying time “DR” 04H 00H 00H m1 m2 m3
[Format]
“DR” 04H 00H 00H m1 m2 m3
[Parameters]
The parameter “m1”, “m2”, “m3” are each one byte binary data.
The parameter “m1” indicate the item shown as below.
Drying position m1
A unit of the switch from the face to the back
(Auto duplex printing)
42H
The “m2” and “m3” indicate the drying time according to the following formura.
(Drying time) = ( ( m3 256 ) + m2 )
0 < (Drying time) < 3600
The unit of time is as follows.
“m1” = 42H : second
[Function]
Set drying time to the temporary default.
The position unit is set with “m1”, and pause for the time set with “m2” and “m3”.
When the unit is page, this command indicates the waiting time from receiving “FF” command until
process the command. (Does not pause when “FF” command is not received.)
The previous setting will be kept if the parameters are out of range.
This command is available only in Remote.
Exception
When roll paper mode is specified, this command is processed after “LD” command is executed (not “FF”
command).
To Next Page
Loading...
Need help?
General