2011/03/02
Revision: 1 Page: 76
6.1.14 User Setting “US” 03H 00H 00H m1 m2
[Format]
“US” 03H 00H 00H m1 m2
[Parameters]
The parameter “m1” , “m2” are each one byte binary data that indicates shown as below.
“m1” Item “m2” Setting
00H Bottom margin setting 00H 0 = Standard
01H 1 = Max
02H 2 =borderless
02H Data cut flag information 00H No cut
01H Cut
04H Economy print setting* 00H Fast-Mode
01H Normal-Mode
05H Load mode setting 00H Fast-Mode(Default)
01H Silent-mode
06H Face Down mode setting 00H Face Up Mode (Default-Mode)
01H Face Down Mode
01H, 03H,
07H - FFH
Reserved
*This command (Economy print setting) is effective only the following mode.
If this command is not used, the product is actuated with Fast-Mode.
Print mode Dot Size
Economy 10H
[Function]
Select a printer setting shown upper to the temporary default.
The previous setting will be kept if the parameters are out of range.
Also, this command will be ignored and skipped if the product does not support this command.
This command is available only in Remote.
To Next Page
Loading...
Need help?
General