2011/03/02
Revision: 1 Page: 74
6.1.12 Select Duplex Printing “DP” 02H 00H 00H m1
[Format]
“DP” 02H 00H 00H m1
[Parameters]
The parameter “m1” is one byte binary data that indicates duplex print setting as shown below.
Duplex Printing m1
Duplex mode off 00H
Duplex mode on 01H
Auto Duplex mode on 02H
Reserved 03H - FFH
[Function]
m1=01H :
(1)The printer fixes the I/F that this command is received one .
(2)The printer switches to the duplex printing mode.
(3)State Reply is changed.
m1=00H :
(1)The printer releases the fixed I/F.
(2)The printer switches to the normal mode.
Select a duplex printing mode to be used for the temporary default.
The previous setting will be kept if the product does not have the character set selected with the parameter
“m1”.
Also, this command will be ignored and skipped if the product does not support this command.
This command is available only in Remote.
To Next Page
Loading...
Need help?
General