Epson RC700 - Page 200

Maintenance 9. Troubleshooting
188 RC700 / RC700-A Rev.23
No. Message Remedy Note 1 Note 2
2056
Object file operation failure.
Global variable ID failure. Rebuild
the project.
Synchronize the files of the project.
Rebuild the project.
2057
Object file operation failure.
Global Preserve variable ID failure.
Rebuild the project.
Synchronize the files of the project.
Rebuild the project.
2058
Object file operation failure.
Failed to calculate the variable size.
Synchronize the files of the project.
Rebuild the project.
2059
Exceed the global variable area.
Cannot assign the Global variable
area because it failed to allocate
memory.
Reduce the number of Global
variables to be used.
2070
SRAM failure.
SRAM is not mapped.
Replace the CPU board.
2071
SRAM failure.
Cannot delete when Global
Preserve variable is in use.
Perform the same processing after a
while. Rebuild the project.
2072
Exceed the backup variable area.
Cannot assign the Global Preserve
variable area because it failed to
allocate memory.
Reduce the number of Global
Preserve variables to be used.
Maximum
size
The size you
attempted to
use
2073
SRAM failure.
Failed to clear the Global Preserve
variable area.
Rebuild the project.
2074
SRAM failure.
Failed to clean up the Global
Preserve variable save area.
Reboot the controller.
2100
Initialization failure.
Failed to open the initialization file.
Restore the controller configuration.
2101
Initialization failure.
Duplicated initialization.
Reboot the controller.
2102
Initialization failure.
Failed to initialize MNG.
Reboot the controller.
2103
Initialization failure.
Failed to create an event.
Reboot the controller.
2104
Initialization failure.
Failed to setup a priority.
Reboot the controller.
2105
Initialization failure.
Failed to setup the stack size.
Reboot the controller.
2106
Initialization failure.
Failed to setup an interrupt process.
Reboot the controller.
2107
Initialization failure.
Failed to start an interrupt process.
Reboot the controller.
2108
Initialization failure.
Failed to stop an interrupt process.
Reboot the controller.
2109
Initialization failure.
Failed to terminate MNG.
Reboot the controller.
2110
Initialization failure.
Failed to allocate memory.
Reboot the controller.
2111
Initialization failure.
Failed to initialize motion.
Restore the controller configuration.
2112
Initialization failure.
Failed to terminate motion.
Reboot the controller.