Epson RC700 - Page 211

Maintenance 9. Troubleshooting
RC700 / RC700-A Rev.23 199
No.
Message
Remedy
Note 1
Note 2
2360
File failure.
Failed to open the configuration file.
Restore the controller configuration.
2361
File failure.
Failed to close the configuration file.
Restore the controller configuration.
2362
File failure.
Failed to open the key of the
configuration file.
Restore the controller configuration.
2363
File failure.
Failed to obtain a string from the
configuration file.
Restore the controller configuration.
2364
File failure.
Failed to write in the configuration
file.
Restore the controller configuration.
2365
File failure.
Failed to update the configuration
file.
Restore the controller configuration.
2370
The string combination exceeds the
maximum string length.
The maximum string length is 255.
Review the program.
Combined
string length
2371 String length is out of range.
The maximum string length is 255.
Review the program.
The specified
length
2372
Invalid character is specified after
the ampersand in the Val function.
Review the program.
2373
Illegal string specified for the Val
function.
Review the program.
2374
String Failure. Invalid character
code in the string.
Review the program.
2380
Cannot use ' 0 ' for Step value in
For...Next.
Check the Step value.
2381
Relation between For...Next and
GoSub is invalid. Going in or out
of a For...Next using a Goto
statement.
Review the program.
2382
Cannot execute Return while
executing OnErr.
Review the program.
2383
Return was used without GoSub.
Review the program.
Review the program.
2384
Case or Send was used without
Select. Review the program.
Review the program.
2385
Cannot execute EResume while
executing GoSub.
Review the program.
2386
EResume was used without OnErr.
Review the program.
Review the program.
2400
Curve failure.
Failed to open the Curve file.
Reboot the controller.
Create a Curve file again.
2401
Curve failure.
Failed to allocate the header data of
the curve file.
Reboot the controller.
Create a Curve file again.
2402
Curve failure.
Failed to write the curve file.
Reboot the controller.
Create a Curve file again.
2403
Curve failure.
Failed to open the curve file.
Reboot the controller.
Create a Curve file again.
2404
Curve failure.
Failed to update the curve file.
Reboot the controller.
Create a Curve file again.
2405
Curve failure.
Failed to read the curve file.
Reboot the controller.
Create a Curve file again.