Epson RC700 - Page 230

Maintenance 9. Troubleshooting
218 RC700 / RC700-A Rev.23
No. Message Remedy Note 1 Note 2
3217 Input bit label was not specified.
Input bit label is not specified in
SetSW, CTReset statement, Sw, and
Ctr function. Specify a valid input bit
label.
3218 Input byte label was not specified.
Input byte label is not specified in
SetIn statement, In, and InBCD
function. Specify a valid input byte
label.
3219 Input word label was not specified.
Input word label is not specified in
SetInW statement, InReal, and InW
function. Specify a valid input word
label.
3220 Output bit label was not specified.
Output bit label is not specified in On,
Off statement, and Oport function.
Specify a valid output bit label.
3221 Output byte label was not specified.
Output byte label is not specified in
Out, OpBCD statement, and Out
function. Specify a valid output byte
label.
3222
Output word label was not
specified.
Output word label is not specified in
OutW, OutReal statement, OutW,
and OutReal function. Specify a
valid output word label.
3223 Memory bit label was not specified.
Memory bit label is not specified in
MemOn, MemOff statement, and
MemSw function. Specify a valid
memory bit label.
3224
Memory byte label was not
specified.
Memory byte label is not specified in
MemOut statement and MemIn
function. Specify a valid memory
byte label.
3225
Memory word label was not
specified.
Memory word label is not specified in
MemOutW statement and MemInW
function. Specify a valid memory
word label.
3226 User error label was not specified.
User error label is not specified in
Error statement. Specify a valid
user error label.
3227 Function name was not specified.
Function name is not specified in the
statement that requires function
name designation, such as Call and
Xqt. Specify a valid function name.
3228 Variable type was not specified.
Variable type is not specified for the
parameter definition of Function
statement and Preserve parameter
specification of Global statement.
Specify a correct variable type.
3229
Invalid Trap statement parameter.
Use Goto, Call, or Xqt.
Specify either GoTo, Call, or Xqt as a
parameter of Trap statement.
3230 Expected For/Do/Function.
Specify either For, Do, or Function as
a parameter of Exit statement.
3231 Above/Below was not specified.
Setting value for the elbow orientation
is not specified in Elbow statement.
Specify either Above or Below.
3232 Righty/Lefty was not specified.
Setting value for the hand orientation
is not specified in Hand statement.
Specify either Righty or Lefty.