Epson RC700 - Page 242

Maintenance 9. Troubleshooting
230 RC700 / RC700-A Rev.23
No. Message Remedy Note 1 Note 2
3451
Force property name, status name,
or object name is not specified.
Add either of a property name,
status name, or object name.
Either of Force property name, status
name, or object name is not specified
in FSet, FGet, MPSet, and MPGet
statements.
Add either of a property name, status
name, or object name.
3452
Force object name is not specified.
Add a force object name.
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
3453
Mass Property Object is not
specified.
Specify a Mass Property Object.
Specify a valid Mass Property object.
3454
Force Coordinate System Object is
not specified.
Specify a Force Coordinate System
Object.
Specify a valid Force Coordinate
System object.
3455
Force Control Object is not
specified.
Specify a Force Control Object.
Specify a valid Force Control object.
3456
Force Monitor Object is not
specified.
Specify a Force Monitor Object.
Specify a valid Force Monitor object.
3457
Force Trigger Object is not
specified.
Specify a Force Trigger Object.
Specify a valid Force Trigger object.
3458
Force Control Object or Force
Coordinate System Object is not
specified.
Specify a Force Control Object or
Force Coordinate System Object.
Force Control data or Force
Coordinate System data is not
specified in FCSMove statement.
Specify a valid Force Control object
or Force Coordinate System object.
3459
Force object is not specified.
Specify a Force object.
3460
Force object label is not specified.
Specify a Force object label.
3461
Force object or label is not
specified.
Specify a Force object or label.
3462
Force Coordinate System Object or
label is not specified.
Specify a Force Coordinate System
Object or label.
Specify a valid Force Coordinate
System object or label.
3463
Force Control Object or label is not
specified.
Specify a Force Control Object or
label.
Specify a valid Force Control object
or label.
3464
Force Monitor Object or label is not
specified.
Specify a Force Monitor Object or
label.
Specify a valid Force Monitor object
or label.
3465
Force Trigger Object or label is not
specified.
Specify a Force Trigger Object or
label.
Specify a valid Force Trigger object
or label.
3466
Mass Property Object or label is not
specified.
Specify a Mass Property Object or
label.
Specify a valid Mass Property object
or label.