Epson SC-F10000 Series User Manual

Item Parameter Explanation
Media 01 XXXXXXXXXX to
50 XXXXXXXXXX
Choose the media settings to use. The registered name appears in
XXXXXXXXXX.
Media Width
Set Width Detection, and when that setting is Off , Media Width.
Pass Mode
Set the Pass Mode for the media settings that are currently selected.
Advanced Settings
Set the content of Advanced Settings for the media settings that are
currently selected.
See the following table for details on the setting content.
U “Media Setting Item” on page 160
Print Adjustments Set these in the following cases.
❏ Using new media not registered to the printer
❏ When banding or graininess is found in the print results even after
Automatic Adjustment is performed
❏ When changing Advanced Settings after saving media settings
❏ When the media type is the same but the width is different
Normally, do Automatic Adjustment first. If banding or graininess is still
found in the print results after doing automatic adjustment, do Print
Head Alignment and Media Feed Adjustment manually.
U “Media Setting Item” on page 160
Automatic Adjustment
Print Head Alignment Auto
Manual(Simple)
Manual(Standard)
Media Feed Adjust‐
ment
Auto(Standard)
Auto(Details)
Manual(Standard)
Manual(Measureme
nt)
Media Management
01 XXXXXXXXXX to 50 XXXXXXXXXX Change the registered media settings. New registrations are normally
done when loading media or in advance on the provided Epson Edge
Dashboard.
U “Media Setting Item” on page 160
Manage Remaining Amount
Manage Remaining
Amount
On
Select On and set the length of the media when loading media, and you
can manage remaining amounts as shown below.
❏ The remaining amount of media and the time until you need to
replace the media are shown in the Home screen.
❏ Displays a warning message for the remaining amount of media.
❏ Print the remaining amount when media is cut.
Off
*
Remaining Amount 1.0 to 9999.0 m
(120.0 m
*
)
Enter a value for overall roll length between 1.0 and 9999.0 m. You can set
in 0.1-m increments.
Remaining Alert 1.0 to 999.5 m (5.0
m
*
)
A warning message is displayed if the amount of media remaining reaches
this length. Choose a value between 1.0 and 999.5 m. You can set in 1-m
increments.
Print Length Management
SC-F10000 Series User's Guide
Control Panel Menu
159

Epson SC-F10000 Series Specifications

General

Brand	Epson
Model	SC-F10000 Series
Category	Printer
Language	English